11-25-2013 10:19 PM - edited 03-07-2019 04:47 PM
im unable to enable ip routing in the WS-C3750X-24T-L switch. Tried with SDM prefer routing option but still same issue.
Can some suggest on this?
MOdel: WS-C3750X-24T-L
IOS :flash:c3750e-ipbasek9-mz.122-55.SE5.bin
sh license
Index 1 Feature: ipservices
Period left: 0 minute 0 second
Index 2 Feature: ipbase
Period left: 0 minute 0 second
Index 3 Feature: lanbase
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Priority: Medium
License Count: Non-Counted
regards,
Ezra.
11-25-2013 10:54 PM
Did u tried:
Switch(config )# ip routing
Regards
Sent from Cisco Technical Support iPhone App
11-25-2013 11:39 PM
hi sandeep,
there is no option to enable ip routing in the switch.
(config)#ip routing
^
% Invalid input detected at '^' marker.
11-25-2013 11:50 PM
Hi,
Pls enable this command
sdm prefer lanbase-routing
reload the switch & then try
Pls rate if helpful
Br/Suibhojit
11-25-2013 11:54 PM
HI Ezra,
Please update your licence.
Contact your cisco supplier, and buy the upgraded license.
Regards
Dontforget to rate helpful posts.
11-26-2013 01:43 AM
Index 3 Feature: lanbase
Period left: Life time
License Type: Permanent
License State: Active, In Use
You don't have the license to run routing.
11-26-2013 02:51 AM
So the only option is to enable licence?
11-26-2013 02:53 AM
Index 1 Feature: ipservices
Period left: 0 minute 0 second
You can't enable the IP Services DEMO license because you've used it all up.
Your only option is to purchase the IP Service license from your authorized Cisco reseller.
11-26-2013 02:53 AM
HI,
Hope you have tried this option
Pls enable this command
sdm prefer lanbase-routing ---> this is to help us to enable 'ip routing' with non routing supported image
Reload the switch & then try to enable 'ip routing'
Br/Subhojit
11-26-2013 02:53 AM
Update the new image which supports ip routing .
Regards
Sent from Cisco Technical Support iPhone App
11-26-2013 02:58 AM
Hi suibhojit,
i dont have option to enable the option sdm prefer lanbase-routing.
config)#sdm prefer ?
access Access bias
default Default bias
dual-ipv4-and-ipv6 Support both IPv4 and IPv6
routing Unicast bias
vlan VLAN bias
11-26-2013 03:01 AM
HI,
Just check with routing once,
then reload & try to give 'ip routing'
Br/Subhojit
11-26-2013 03:07 AM
tried with that... but no luck.
11-26-2013 04:02 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide