unable to enable routing in 3750x switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-25-2013 10:19 PM - edited 03-07-2019 04:47 PM
im unable to enable ip routing in the WS-C3750X-24T-L switch. Tried with SDM prefer routing option but still same issue.
Can some suggest on this?
MOdel: WS-C3750X-24T-L
IOS :flash:c3750e-ipbasek9-mz.122-55.SE5.bin
sh license
Index 1 Feature: ipservices
Period left: 0 minute 0 second
Index 2 Feature: ipbase
Period left: 0 minute 0 second
Index 3 Feature: lanbase
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Priority: Medium
License Count: Non-Counted
regards,
Ezra.
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-25-2013 10:54 PM
Did u tried:
Switch(config )# ip routing
Regards
Sent from Cisco Technical Support iPhone App
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-25-2013 11:39 PM
hi sandeep,
there is no option to enable ip routing in the switch.
(config)#ip routing
^
% Invalid input detected at '^' marker.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-25-2013 11:50 PM
Hi,
Pls enable this command
sdm prefer lanbase-routing
reload the switch & then try
Pls rate if helpful
Br/Suibhojit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-25-2013 11:54 PM
HI Ezra,
Please update your licence.
Contact your cisco supplier, and buy the upgraded license.
Regards
Dontforget to rate helpful posts.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2013 01:43 AM
Index 3 Feature: lanbase
Period left: Life time
License Type: Permanent
License State: Active, In Use
You don't have the license to run routing.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2013 02:51 AM
So the only option is to enable licence?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2013 02:53 AM
Index 1 Feature: ipservices
Period left: 0 minute 0 second
You can't enable the IP Services DEMO license because you've used it all up.
Your only option is to purchase the IP Service license from your authorized Cisco reseller.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2013 02:53 AM
HI,
Hope you have tried this option
Pls enable this command
sdm prefer lanbase-routing ---> this is to help us to enable 'ip routing' with non routing supported image
Reload the switch & then try to enable 'ip routing'
Br/Subhojit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2013 02:53 AM
Update the new image which supports ip routing .
Regards
Sent from Cisco Technical Support iPhone App
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2013 02:58 AM
Hi suibhojit,
i dont have option to enable the option sdm prefer lanbase-routing.
config)#sdm prefer ?
access Access bias
default Default bias
dual-ipv4-and-ipv6 Support both IPv4 and IPv6
routing Unicast bias
vlan VLAN bias
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2013 03:01 AM
HI,
Just check with routing once,
then reload & try to give 'ip routing'
Br/Subhojit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2013 03:07 AM
tried with that... but no luck.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-26-2013 04:02 AM
