As what Glen (below) stated,

sherif_mohamed5 · ‎06-15-2016

Hello,

I need to upgrade my CISCO switch IOS but I have no Available space in the flash for the 2 IOS. can I delete the available IOS and in the same session I downloaded the new IOS or the switch will crach

my cisco switch is 3560-48PS

Leo Laohoo · ‎06-15-2016

Post the complete output to the command "dir".

What IOS version & what feature set are you trying to upgrade to?

sherif_mohamed5 · ‎06-15-2016

Dear Leo,

the below is the dir

Switch#dir
Directory of flash:/

2 -rwx 5 Mar 1 1993 09:13:45 +00:00 private-config.text
3 -rwx 1036 Mar 1 1993 01:43:42 +00:00 vlan.dat
4 -rwx 9314 Dec 24 1993 07:19:13 +00:00 config.old
5 drwx 192 Mar 1 1993 00:09:08 +00:00 c3560-ipbase-mz.122-35.SE5
463 -rwx 5858 Mar 1 1993 09:13:45 +00:00 config.text

15998976 bytes total (6928384 bytes free)
Switch#

I need to upgrade the IOS to

c3560-ipbasek9-mz.122-55.SE10

to Support the service policy so to be able to rate limit a special interface'

Leo Laohoo · ‎06-15-2016

Ok, use this command: archive download-sw /over tftp://<TFTP IP address>/IOS_filename.tar

Remember, use the IOS file with the TAR file extension.

troytennant.ct113186 · ‎01-16-2017

Leo I'm in the same situation with a 3550. My question is if i load the K9 ios does it require me to enter a license key ?

regards Troy

glen.grant · ‎01-16-2017

normally there is no special requirements needed to download a K9 file .

Leo Laohoo · ‎01-16-2017

As what Glen (below) stated, no special requirement needed. You can upgrade to K9.

Philip D'Ath · ‎06-15-2016

If this is a newer Cisco 3650 then;

You should be able to do a "software install file ..." and install it that way. It should cleanup and remove any files to create enough space for the installation.

I often put the new software on a usb memory key, plug it into the switch, and install it from there.

If this is an older 3560 switch, use the "archive download-sw ..." command with a full install bundle. It will remove the old software as needed.

sherif_mohamed5 · ‎06-15-2016

Dear Philip,

how i can use the archive download-sw command. as i need to upgrade

from

c3560-ipbase-mz.122-35.SE5

to

c3560-ipbasek9-mz.122-55.SE10 (11.5 Mbyte)

and the only available memory is (6928384 bytes free)

Philip D'Ath · ‎06-15-2016

The archive command should remove the old software for you.

upgrading the IOS