08-06-2017 06:04 AM - edited 03-08-2019 11:38 AM
I have a catalyst 2960 series, ws-c2960-48tt-l with a bad image. I upload an image from the cisco website c2960-lanbasek9-mz.122-55.SE11.bin. When boot require user and password. Can't login
Regards
Solved! Go to Solution.
08-06-2017 08:27 AM
Hello,
there is no default username/password. You could try admin/cisco, but that probably won't work.
Try and reset the switch to factory defaults by pressing and holding the Mode button. The switch LEDs begin blinking after about 3 seconds. Continue holding down the Mode button. The LEDs stop blinking after 7 more seconds, and the switch reboots.
Make sure you are connected through the console port.
08-06-2017 08:27 AM
Hello,
there is no default username/password. You could try admin/cisco, but that probably won't work.
Try and reset the switch to factory defaults by pressing and holding the Mode button. The switch LEDs begin blinking after about 3 seconds. Continue holding down the Mode button. The LEDs stop blinking after 7 more seconds, and the switch reboots.
Make sure you are connected through the console port.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide