VLAN Ip configuration problem

[vishwajitroy]

Hi All

When I am trying to configure ip,no response from SG300 switch.Waiting continuously.Please help me ,how to solve this.

[mohammed01701]

Hi!

What are you trying to change? If you are changing from 192.168.1.0/24 to 10.10.2.0/24 you have to change also the pc you using to the new subnet 10.10.2.x/24 efter that you Will get some respons from THE switch.

HTH

/Mohammed

[vishwajitroy]

Thank you for your answer.I have not changed switch default ip (192.168.1.254).MY pc is 192.168.1.207.I need to configure vlan 10(10.10.2.0-untagged port 3&4) and vlan 20(192.168.5.2 -untagged port 5&6). I am able to assign port for vlan 10 and 20.But when I am trying to configure IP for both vlan 10 and 20,it is not working.Can you please tell me what to change.

Thank you again for your help.

[Deepak Kumar]

Hi,

By Default, SG300 switches are coming with L2 (Layer Mode) so you can configure only one IP per switch (one IP on any SVI). So it will overwrite the default IT address and not respond to you. 

The best solution to convert in Layer 3 mode so you can configure multiple IPs on the switch (Different Subnet on Different SVI/Loopback).

Regards,

Deepak Kumar

[vishwajitroy]

Hi Deepak I have changed the switch to Layer 3 mode.Can you please give the link for vlan configuration steps. thanks.

[Deepak Kumar]

Hi,

Here, I am sharing a link for your reference. 

https://sbkb.cisco.com/CiscoSB/GetArticle.aspx?docid=67844b99e2da4a7f88db0c588197487d_Creating_VLANs_on_Cisco_Managed_Switches.xml

Regards,

Deepak Kumar

[vishwajitroy]

Hello Deepak kumar

Thank you for your mail.I am facing the problem of IP configuration.I have untagged port 5 as access port to vlan 10.I am trying to configure ip 192.168.5.200 to VLAN 10.But it is not saving in switch.I have attached the screenshot for that.Please let me know what to change.

Thank you.

Roy