WAN and bandwidth help needed

[Michael Durham]

I am getting a 50Mbs fiber internet connection in a few weeks and I will be sharing it with my neighbors.  The only option here is AT&T dedicated service which is very expensive. So we share it.

I am using a Cisco 3750v2 switch with IOS 15.0 and I have all the wiring to their houses done and working.  Each house will get a dedicated static public IP address.

What I would like to do is set each port to provide a minimum of 5Mbs per port (house) but if the full 50Mbs is available, they should be allowed to use the full 50Mbs.

The switch has a maximum bandwidth option but how do I set a minimum and allow the more if available?

[balaji.bandi]

here is good document and once you build the config and tested, let us know any issue, we can asists you if you have any issue

https://www.cisco.com/c/en/us/support/docs/quality-of-service-qos/qos-packet-marking/10100-priorityvsbw.html

[Michael Durham]

Thank you for that information, I read it fully.

But... things have changed a little.  Here is my new needs.

Everyone (5-10 users) will have their one static public IP address.  I need to provide a minimum 5Mbs to each person based on IP addresses and not based on class other than VoIP which must have priority.

AT&T provided us a Cisco 4331 router and we have full access to the command line and we have a Cisco 3750G switch.

Any suggestions?

[Michael Durham]

Any suggestions?????

[balaji.bandi]

I have suggested the URL above, have made any configuration and tested? where did you suck now?