09-10-2018 10:16 AM - edited 03-08-2019 04:07 PM
Working on configuring new C9300 switches. In the getting started guide for configuration it indicates I can plug PC into any unmanaged network port on the switch and use the WEBUI site at 192.168.1.1 to configure the switch. The PC must be configured for DHCP and it should get an IP from the switch.
This is not working and looking to see if there is a service to start on the switch.
I can connect to the switch console port and access the cli. Limited CLI experience and would prefer the GUI to configure the switch.
Solved! Go to Solution.
01-28-2019 07:56 AM
01-28-2019 07:57 AM
Hi Bobby, thanks for the info but what do you mean Cisco pulled down a config? Also, which port did you plug into and did it auto assign you an ip or did you have to manually put one on your nic card? Thanks.
01-28-2019 02:32 PM
I ended up opening a ticket with TAC and they helped restore the switch to the factor settings. In the process they download a new config file used it to reset the switch.
01-28-2019 04:53 PM
Ok, thanks for the info.
06-22-2019 09:20 PM
Can you share an information on what TAC did and the new configuration file they provided?
Thx
Bryan
07-08-2019 11:22 AM
Hi,
I am having the same issue.. UN: cisco, and webui do not work... what were the steps TAC gave to fix this?
05-20-2019 03:00 AM
HI Bobby,
im facing the smae issue on my new 9200 the docx says that username is cisco and the default password si the SN. But, does not work on me. anyone who solve this issue?
09-11-2018 01:06 PM
It should be the S/N of the device, did you get the S/N from a sticker on the switch?
Did you try both upper case and lower case version of the letters? I am guessing it is case-sensitive.
Optionally you could boot it up again and log in via CLI and issue the show inventory command to confirm the S/N is correct, then just run the write erase again and reboot.
09-11-2018 01:32 PM
Serial number is correct but it turns out the user name is no longer webui but cisco. Cisco TAC found the information not update for version 16.8.1
09-11-2018 04:49 PM
Hello
thanks for that - A nice little bit of information to keep retain
01-19-2021 12:22 AM - edited 01-19-2021 12:23 AM
i had same issue with 9300
it gives me ssl error or mismatch.
do the followinf
#cry key rsa zeroize
#no ip http secure-server
#ip http secure-server
2-seconds timeout on cli.... it re-genetared keys..
and you are in!
it solved my problem.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide