08-27-2007 11:23 AM - edited 03-05-2019 06:07 PM
I just installed a device in my vlan 6
When I connect my laptop in vlan 6 I can access the device.
When I connect my laptop in vlan 1 I cant access the device.
If I add a static arp in my core switch:
arp 10.30.4.122 0020.4a52.15f3 ARPA
then it start to work.
After that even if I remove the line in config it will work until I reboot the core switch even if I do a:
clear mac-address-table
clear arp-cache
Any suggestion were to start looking ?
08-27-2007 11:32 AM
Hi,
did you checked the routing settings among the existing VLANs? It seems a problem with routing, since you connect on the same VLAN and can reach the device and in another VLAN you can?t. Try to check the settings on the L3.
Regards.
08-27-2007 11:34 AM
I don't see how it could be a routing problem.
I can connect to the device after I make a static arp entry. So the routing is working.
08-30-2007 05:06 AM
How can you remove a static ARP int the memory without rebooting the switch ?
08-30-2007 10:04 AM
Check the default gateway defined on the device itself.
08-30-2007 12:31 PM
I checked the gateway on the device and it is set properly. But If it works after adding the static arp I don't see how it could be the gateway.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide