cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4712
Views
0
Helpful
8
Replies

Wireless clients cannot see eachother from same ssid and same access point

mark.nelson
Level 1
Level 1

I have a cisco 871w wireless router/switch.  I have an ssid set up and clients can connect and access network/internet resources EXCEPT for anything other wireless device on the access point.

From a wireless client (ipad, iphone, or laptop) i can ping the bvi interface.

I can ping the gateway

I can ping anything outside of the 871w. 

From outside the access point...i can ping the wireless device.

However...i cannot ping from 1 wireless device to another on the same access point.

I know there are no firewalls or access lists involved.  I saw some references to making sure the bridge-group subscriber-loop-control is configured (is by default).

I have the same problem on an 881w device as well...so i figure it must be something i am not doing. 

Any suggestions?

Here is the config:

871w#sh run

Building configuration...

Current configuration : 5658 bytes

!

version 12.4

no service pad

service timestamps debug datetime msec

service timestamps log datetime msec

service password-encryption

!

hostname 871w

!

boot-start-marker

boot-end-marker

!

logging buffered 51200 warnings

enable password

!

no aaa new-model

!

dot11 ssid INTERNAL

   vlan 1

   authentication open

!

ip cef

no ip dhcp use vrf connected

ip dhcp excluded-address 192.168.30.200 192.168.30.254

!

ip dhcp pool INTERNAL

   network 192.168.30.0 255.255.255.0

   dns-server 10.1.5.11 10.1.5.33

   domain-name stoops.com

   default-router 10.1.4.102

!

!

no ip domain lookup

ip domain name yourdomain.com

!

!

!        

vtp mode transparent

!

!

archive

log config

  hidekeys

!

!

!

bridge irb

!

!

interface FastEthernet0

!

interface FastEthernet1

!

interface FastEthernet2

!

interface FastEthernet3

!

interface FastEthernet4

ip address 10.1.4.102 255.255.255.0

ip nat outside

ip virtual-reassembly

duplex auto

speed auto

!

interface Dot11Radio0

no ip address

!

encryption vlan 1 mode wep optional

!

ssid INTERNAL

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

station-role root access-point

!

interface Dot11Radio0.1

encapsulation dot1Q 1 native

no cdp enable

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

interface Vlan1

description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$$ES_LAN$

no ip address

ip nat inside

ip virtual-reassembly

ip tcp adjust-mss 1452

!

interface BVI1

ip address 192.168.30.254 255.255.255.0

ip nat inside

ip virtual-reassembly

!

ip forward-protocol nd

ip route 0.0.0.0 0.0.0.0 10.1.4.253

!

ip http server

ip http authentication local

ip http secure-server

ip http timeout-policy idle 60 life 86400 requests 10000

!

access-list 23 permit 10.10.10.0 0.0.0.7

no cdp run

!

!

!

control-plane

!

bridge 1 protocol ieee

bridge 1 route ip

!

line con 0

login local

no modem enable

line aux 0

line vty 0 4

privilege level 15

password

login

transport input telnet ssh

!

scheduler max-task-time 5000

end

871w#