07-09-2012 06:59 PM - edited 03-07-2019 07:41 AM
Hi,
I need to connect a 6500 switch with a 4948 switch using 10G optics.
On 6500, line card used is WS-X6704-10GE and I am aware that WS-X6704-10GE is a xenpak and 4948 ports are X2. What is the way to make the connection between xenpak and X2 work?
Thanks,
Kashish
Solved! Go to Solution.
07-09-2012 09:44 PM
07-09-2012 09:44 PM
Make sure you use the same at each end.
LR and LR or SR and SR.
07-09-2012 09:47 PM
Thanks Leo. That's what I thought ( From https://supportforums.cisco.com/thread/141785)
.
07-09-2012 09:50 PM
Thanks Kashish.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: