I can't seem to find the right setting to have audio through the quad cam speakers. I have a codec plus, HDMI input 1 is used for the camera, and from what I read, audio in supposed to go to the camera through that same HDMI connection, Is there a setting I am missing to make this work?
Solved! Go to Solution.
I had that problem. I had the quad camera set to shutdown with the monitors after the customer was finished using the system, and sometimes when it restarted it received the audio signal, and sometimes it did not. I disassociated the camera from the automated power shut down and left it "always on" and I never had the problem again.
I know this is way late, but I wanted to put the correct info out there because the info looks limited so far.
For the Cisco Quad Camera Speakers to work a few things need to happen:
If you follow the above the Quad Camera audio will function. Feel free to disagree or not follow this as I just wanted to put the info, I discovered out there.
Hi Nazim, Thank you for the information. I would also add that if all else fails you can go with a direct audio cable as suggested in this solution.