Changing calling id / name for SIP URI calls to VCS

[jecker]

Hello,

I have CUCM 9.1 clusted with a SIP trunk to a VCS-C.  When making calls, the calls show a caller-id of extenstion@ip address, for exampe 2500@172.16.1.5.  I have a directory URI setup on the phone that is generating the call, but it's now showing the URI.  Inbound SIP URI calls are working fine.

Thanks

[George Thomas · Accepted solution]

Hello,

On the SIP trunk to VCS, under outbound calls, there should be a setting: Calling and Connected Party format, change it to Deliver URI only in connected party. Also, under the SIP profile assigned to the SIP trunk to VCS, there should be a setting Use Fully qualified domain in requests, check this checkbox. The SIP profile should also be assigned to the SIP device making calls.

HTH, if so please rate.

[gfolens]

Hello,

I've made above changes but I still see the IP address of the cucm instead of the domain in the URI...

See attached screenshots.

rgds, Geert.

[George Thomas]

Did you create a directory URI under the extension?