Cisco EQ Codec with CCS-MIC-ARRAY-T wiring.

[IsaacOwen1984]

I am finding the wiring for the new EQ Codec is not documented in much detail - Can anyone point me to the correct place... The mic array install doc suggests a switch but doesn't show all the wiring options.

Do I need two switches as per below or can I put everything Navigator and mics on the client network and have it all connect via the network? Or even just use one switch and then have that connect to 'Panel' or 'POE 1' network ports?

Regards,

[Jonathan Schulenberg]

The Table Microphone Pro is an Ethernet-connected PoE microphone; that is the only cabling option. I believe it must be connected, either directly or via a L2 switch, to the private network port of the codec. The Room Navigator panel can be paired across the LAN but it’s easier and less susceptible to issues if you connect it to the private network as well.

[cdominguez@kinly.com]

Thanks Jonathan for this, Is there a license key required for this option and if so, do you have the part # you can share?

[IsaacOwen1984]

Yes for more than 3 mics you need to pay up.

https://help.webex.com/en-us/article/k35sdq/AV-integrator-license