cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
616
Views
5
Helpful
2
Replies

Cisco IX5000 supports H.323

doanhuuhiep
Level 1
Level 1

Hi all.

I have a question that Cisco IX5000 supports H.323 protocol.

There is only SIP in the datasheet I checked. But, my customer don't want to buy CUCM. They only want to call point-to-point between 2 IX5000.

Thanks.

1 Accepted Solution

Accepted Solutions

A CUCM as a call control and provides SIP signaling for TelePresence System IX5000 is required for the system to work. A CUCM is needed for the system to get its configuration via TFTP. 

You can find the document provided on the link below:

http://www.cisco.com/c/en/us/td/docs/telepresence/ix5000/first_time_setup/ix5000_first_time_setup.html

regards,

Acevirgil

View solution in original post

2 Replies 2

A CUCM as a call control and provides SIP signaling for TelePresence System IX5000 is required for the system to work. A CUCM is needed for the system to get its configuration via TFTP. 

You can find the document provided on the link below:

http://www.cisco.com/c/en/us/td/docs/telepresence/ix5000/first_time_setup/ix5000_first_time_setup.html

regards,

Acevirgil

Yes it can dial via H323 but not directly. Expressway C/E will do the conversion of SIP to H323