cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
602
Views
5
Helpful
2
Replies

Cisco IX5000 supports H.323

doanhuuhiep
Level 1
Level 1

Hi all.

I have a question that Cisco IX5000 supports H.323 protocol.

There is only SIP in the datasheet I checked. But, my customer don't want to buy CUCM. They only want to call point-to-point between 2 IX5000.

Thanks.

1 Accepted Solution

Accepted Solutions

A CUCM as a call control and provides SIP signaling for TelePresence System IX5000 is required for the system to work. A CUCM is needed for the system to get its configuration via TFTP. 

You can find the document provided on the link below:

http://www.cisco.com/c/en/us/td/docs/telepresence/ix5000/first_time_setup/ix5000_first_time_setup.html

regards,

Acevirgil

View solution in original post

2 Replies 2

A CUCM as a call control and provides SIP signaling for TelePresence System IX5000 is required for the system to work. A CUCM is needed for the system to get its configuration via TFTP. 

You can find the document provided on the link below:

http://www.cisco.com/c/en/us/td/docs/telepresence/ix5000/first_time_setup/ix5000_first_time_setup.html

regards,

Acevirgil

Yes it can dial via H323 but not directly. Expressway C/E will do the conversion of SIP to H323

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: