11-20-2020 04:23 AM
Hey
I want the second output to show exactly the same feed as the main output.
Just as a 1 in 2 out video distribution amp would do.
Will the software allow me to do that right out the box with no additional licence?
Isaac
11-20-2020 07:12 PM
Have you gone through admin guide.
11-22-2020 02:36 AM
Looks like the settings for what each monitor outputs are as the below.
I have looked at it yea and the only way i can think of making both HDMIs output the same is by setting the outputs as per the below. I can not see that it will be allowed though?
Video > Output > Connector 1 > MonitorRole: First
Video > Output > Connector 2 > MonitorRole: First
I do not have a codec to test this on at the moment.
Many thanks
Isaac
11-26-2020 09:49 PM
@IsaacOwen1984 wrote:
Video > Output > Connector 1 > MonitorRole: First
Video > Output > Connector 2 > MonitorRole: First
You'd think that would be the logical way to do it, however from experience you will have better luck if you set them both to "Second"
Please remember to mark helpful responses and to set your question as answered if appropriate.
01-03-2024 02:00 AM
Hi Wayne,
I am supporting Cisco Room devices remotely. Can you please elaborate the better experience you had when setting the two MonitorRoles to Second? I'd like to know more before I make this change. Thank you
01-10-2024 05:48 PM
Setting them both to "First" didn't give the desired outcome (of both screens showing the same). Setting them both to "Second" did. There's no harm in trying it to see if it works for you, then change it back if it doesn't.
Please remember to mark helpful responses and to set your question as answered if appropriate.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide