Hi,
I'm setting up a test environment to allw video calls to pass trough a cube.
9951 - cucm - sip trunk - cube - sip trunk - cucm - jabber for windows
I was able to get it to work for both audio and video, but as soon as I put the call on hold and try to resume, the call is dropped.
This is the relevant config :
voice service voip
ip address trusted list
ipv4 0.0.0.0 0.0.0.0
allow-connections sip to sip
sip
midcall-signaling passthru
pass-thru content sdp
!
!
dial-peer voice 1000 voip
description Inter_Customer_Inbound
session protocol sipv2
incoming called-number +4924141250061
dtmf-relay rtp-nte
codec transparent
no vad
!
dial-peer voice 2000 voip
description Inter_Customer_Outbound
preference 1
destination-pattern +4924141250061
session protocol sipv2
session target ipv4:192.168.12.2
dtmf-relay rtp-nte
codec transparent
no vad
!
dial-peer voice 2001 voip
description Inter_Customer_Outbound
preference 2
destination-pattern +4924141250061
session protocol sipv2
session target ipv4:192.168.12.1
dtmf-relay rtp-nte
codec transparent
no vad
!
Attached is a debug of call put on hold and resumed. thanks for your help.
Jeroen
