12-23-2015 01:19 AM - edited 03-18-2019 05:21 AM
Hello ,
After loading the new firmware of DX series <sipdx80.10-2-5-60> to CUCM, and pushed on an individual DX 80 equipment, after the installation being successful, the system has lost all his configuration (Network).
Do resolve this issue, i need to enter manually the IP ,GTW and the tftp server.
Can you please advise how to get this issue resolved?
Regards,
Firdaush
12-23-2015 05:07 AM
Hi Firdaush,
This is because of a known bug with DX80
https://tools.cisco.com/bugsearch/bug/CSCux14111/?reffering_site=dumpcr
01-08-2016 06:03 AM
Hi Manish,
Known affected release: 10.2(4) from the BugID you stated nut not the sipdx80.10-2-5-60.
01-27-2016 12:17 PM
I had the same thing happen when upgrading to 10-2-5 (154)
Any ETA on a fix?
:(
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide