You need more than just the

mohammad saeed · ‎07-09-2015

Hi Experts,

I have codec C20 with one project and two EX60 in another project and I want to make multi-site session between them, what do I need to do this option?

Thanks

Mohammad Saeed

Anthony Thomson · ‎07-09-2015

C20 and EX60 do not support the Multisite option, so that means you need a 3rd party bridging service, like CMR Cloud, or a codec that does support Multisite to perform the bridging for the call. An SX20 would support this feature.

mohammad saeed · ‎07-09-2015

OK. what if I want to make multi site session with Codec C20, could that happen if I had CUCM?! !

Jens Didriksen · ‎07-09-2015

No, you still need an MCU, or a bridging service as mentioned by Anthony, to actually host the call..

/jens

Please rate replies and mark question(s) as "answered" if applicable.

Wayne DeNardi · ‎07-09-2015

You need more than just the basic CUCM. If you're considering going down that path, have a look at Cisco Personal Multiparty.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.

EX60 and codec c20 for multisite