02-19-2002 11:47 AM - edited 03-17-2019 07:51 PM
Is there someone who could email me a guide to get this working? I need to setup basic un-secure access to a couple of external sites using polycom FX, Viewstation, and possibly a picturetel 760XL through a PIX 520. I've got dynamic NAT setup but still no joy. I'm not sure I need the higher functions of MCM/gatekeeper but perhaps this is necessary?
TIA
02-20-2002 10:18 PM
You need the higher functions of Cisco MCM/GK to work in conjunction with PIX firewalls more elegantly. I'll forward the PIX video config guide under separate cover...
06-20-2002 05:53 PM
Can you send this paper to me too? patrick.hurley@sbc.com
10-25-2002 05:55 AM
sent in error
Mark
01-20-2003 08:51 AM
Can you send me this document to? sacarpenter@spro.net
11-07-2002 09:41 AM
Keep in mind that the PIX only does H323 version 4 right now. And there are version of the Polycom Ipower , like 4.0.5 that use H323 version 4 and this is incompatible right now. ALso, the PIX will need a cersion of code that can read the H323 information in order to do NAT.
Just some gotchas to avoid.
01-20-2003 08:59 AM
I wanted to see if someone could clarify the statement above. It was my understanding that 6.2.1(x) of the PIX code only supported H323 version 2 and not version 4 which is what most Polycom equipment uses.
I had heard though that code base 6.2.2(x) was going to support the newer H323 version 4, but I cannot find anywhere to verify this. Does anyone know where to find the answer? THX
02-06-2003 12:25 PM
Are you still having problems getting this to work? Cisco has a fix in the latest IOS that allows the newer versions of H323 in through the firewall. Before this was implemented you had to turn Fixup protocol 1720 off.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide