Buy or Renew
Buy or Renew
COMING SOON: Umbrella and Secure Access release notes are coming to Cisco Community. The community will be in read-only August 16 – 19. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
482
Views
0
Helpful
1
Replies

Polish language in EX90 ?

Go to solution
misiakisia
Level 1
Level 1

‎01-30-2013 02:00 AM - edited ‎03-18-2019 12:30 AM

I have EX90 with new TC5.1.6 software. I see in data sheet that EX90 can support polish language. Unfortunately i can't change language to polish by http or ssh. If i try to change language to polish in http menu, after a few seconds language selected in menu is english again. Any suggestions ?

Regards

Luke

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
mubakhta
Level 4
Level 4

‎01-30-2013 05:58 AM

Hi Luke,

It has been identified as a known issue with the software in TC 5. It has been fixed in TC 6. The datasheet does not have the correct information and will be corrected.

Hence, please wait for TC 6 release and you should be able to perform the task successfully.

Thanks

Mubashshir Akhtar
TelePresence Solution Group

Thanks Mubashshir Akhtar

View solution in original post

0 Helpful
1 Reply 1

Go to solution
mubakhta
Level 4
Level 4

‎01-30-2013 05:58 AM

Hi Luke,

It has been identified as a known issue with the software in TC 5. It has been fixed in TC 6. The datasheet does not have the correct information and will be corrected.

Hence, please wait for TC 6 release and you should be able to perform the task successfully.

Thanks

Mubashshir Akhtar
TelePresence Solution Group

Thanks Mubashshir Akhtar
0 Helpful
Customers Also Viewed These Support Documents