01-30-2013 02:00 AM - edited 03-18-2019 12:30 AM
I have EX90 with new TC5.1.6 software. I see in data sheet that EX90 can support polish language. Unfortunately i can't change language to polish by http or ssh. If i try to change language to polish in http menu, after a few seconds language selected in menu is english again. Any suggestions ?
Regards
Luke
Solved! Go to Solution.
01-30-2013 05:58 AM
Hi Luke,
It has been identified as a known issue with the software in TC 5. It has been fixed in TC 6. The datasheet does not have the correct information and will be corrected.
Hence, please wait for TC 6 release and you should be able to perform the task successfully.
Thanks
Mubashshir Akhtar
TelePresence Solution Group
01-30-2013 05:58 AM
Hi Luke,
It has been identified as a known issue with the software in TC 5. It has been fixed in TC 6. The datasheet does not have the correct information and will be corrected.
Hence, please wait for TC 6 release and you should be able to perform the task successfully.
Thanks
Mubashshir Akhtar
TelePresence Solution Group
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide