SIPV2 support under dial-peer

[czerewacz]

Dear Community:

I have an old H323 GW on a Cisco 1760 (32MB  Flash and 16 MB RAM) that would like to test with SIP protocol.

This GW has the IOS: c1700-sv3y-mz.123-13b.bin which as per this link " http://www.cisco.com/en/US/docs/interfaces_modules/cable/line_cards/voice_adapter/cva122_122e/feature/guide/SIP_fm.html " should support the command: session protocol sipv2

The issue is when I try to run that command it does not work:

GW(config-dial-peer)#session protocol sipv2

                                                         ^

% Invalid input detected at '^' marker.

GW(config-dial-peer)#session protocol ?

cisco      Cisco Session Protocol

multicast  Multicast Session Protocol(voice conferencing)

Does anybody knows since which IOS version sipv2 is supported?

Thanks!!

[Daniele Giordano · Accepted solution]

C1700-sv3y-mz is an IP/VOICE PLUS IOS.

Try an IP VOICE c1700-ipvoice-mz.

Regard.

[czerewacz]

Thanks!!