- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-19-2015 12:50 PM - edited 03-18-2019 05:07 AM
Howdy
I have a very basic setup, a home router and behind it SX10. I am unable to access the web interface of the unit remotely. Is there a port i need to enable or something?
When the unit was connected directly to modem, with public IP, I was able to connect the web interface.
any suggestions here?
I did not enter anything in the AllowRemote field.
thanks in advance!!
Solved! Go to Solution.
- Labels:
-
Room Endpoints
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-19-2015 01:52 PM
Web interface can be accessed ether using HTTP (80) or HTTPS (443). Up to you how you'd want to deploy it, but you could use NAT on your router, port forwarding, or even put the SX10 in the router's DMZ.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-19-2015 01:45 PM
If your router support static NAT (Network Address Translation), this would be possible.
regards,
Acevirgil
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-19-2015 01:58 PM
thanks!

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-19-2015 01:52 PM
Web interface can be accessed ether using HTTP (80) or HTTPS (443). Up to you how you'd want to deploy it, but you could use NAT on your router, port forwarding, or even put the SX10 in the router's DMZ.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-19-2015 01:57 PM
