SX80 videocalls with Polycomm Real Presence Group 310

[Grishazahid]

Hello!

Is there any ability to make videocalls between Polycomm Real presense group 310 and Cisco SX80?

I have found document on Polycom web-site.

https://support.polycom.com/global/documents/support/strategic_partner_solutions/Cisco_Solution_Deployment_Guide_us.pdf

It tolds that Real Precence Group can register to CUCM (as third-party-device) and make videocalls (page 14-15). But do SX80 supports TIP protocol?  So now I don't understand, will videocalls from polycom 310 to sx80 work or not? Hope Community will help

[PJMack · Accepted solution]

TIP was only there for connection with legacy Cisco Telepresence endpoint (CTS, etc). Here you'll register both as SIP devices and it should work just fine. 

[George Sotiropoulos · Accepted solution]

You should be able to place SIP calls between the 2 endpoints, considering that the Polycom will be normally registered as 3rd-party Device.

George