TMS Provisioning Extension services: BASE GROUP Configuration Issue

[Nikhil Jayan Kandampully]

I was trying to configure the TMS Provisioning Extension services and i got stuck in Base Group Value?

Error was getting something like the Base group value which i given was wrong. And it's asking me to check with TMS Administrator. Unfortunatly i am the one who configured the TMS also. but i didn't find something like Base Group value.

In my scenario i have two VCS Control, two VCS Expressway, and a TMS. I have the clustering configured on both VCS Control and Expressway. and i need to use TMS Provisioning Extension Service for Cisco Movi.

Where i can find the Base Group Configuration value?

Regards,

Nikhil Jayan

[Magnus Ohm]

Once this is done you can enable the synchronization between tms abd the vcs after you enable the provisioning extension on the vcs.

Sent from Cisco Technical Support iPhone App

[Zawlatt456]

Hi,

I am trying to switch the vcs into extension mode but am getting "connection error refuse" with the VCS for all the services. User, Devices, findme on the TMS. Am i missing anything to do in the TMS? anybody?

[Jens Didriksen]

Most probably an IIS security issue, you can confirm this by turning off encryption in the TMSPE settings on VCS-C itself, and don't forget to change the port to 80.

/jens