Touch 10 and 802.1X

[jayage]

Hi guys,

I am wondering if it is possible to set up dot1x on a TelePresence Touch 10.

We linked it by IP with our SX20 using software version TC7.3.4.e4daf54.

Hardware version is 102310-1. The SX20 itself works fine with 1X.

I didn't find any documentation about this topic..

Hope someone can help.

Thank you!

[Patrick Sparkman]

The Touch 10 authenticates to the endpoint via the admin account, 802.1X isn't mentioned in the Touch 10 data sheet, so don't think it's supported.

[Derek Payne]

I'd like to piggy-back on this thread, as our organization would also like to see a way to do 802.1x authentication on the Touch 10 when paired with a SX10 or SX20 endpoint.

[jayage]

We're now using MAB in combination with VLAN mapping and downloadable ACLs as workaround.

[Derek Payne]

Thank you for your response. We are currently doing something similar.  

[iziks]

Hi,

our clients also ask us for similar solution with Network Access Control,

could you please explain what can be done with touch10?

[jayage]

Our touch 10 devices reside in the same vlan as our video endpoints. If host lookup occurs and MAC is in the according identity group a downloable ACL is set on the port of the touch 10 which allows ip traffic within the above mentionend vlan only.

[iziks]

Hi,

our clients also ask us for similar solution with Network Access Control,

could you please explain me how you deploy MAB with touch 10???

[Enrico Conedera]

Touch 10 devices do not support 802.1X.  The workaround which we use at Cisco is to use exceptions for the Touch 10s o the network.