06-01-2014 03:07 AM - edited 03-18-2019 03:02 AM
Hello,
I have the following question about the integration between VCS and VCS Express behind NAT devices.
In VCS Control in the traversal client zone configuration shall I use the Global (Real) IP Address in Location > Peer Address or I have to use the private IP address.
Thanks
Solved! Go to Solution.
06-01-2014 01:53 PM
Hi,
that depends on how many interface you have connected on the Expressway. So if you have two interfaces connected then the internal one is configured with private address, and that is the one you would use on the Control to send the traffic to. But from you question I assume you have one interface connected only therefore you will have to use the public ip address to sent traffic to from vcs control.
Ask if you need more information.
Regards//Andrey
06-01-2014 01:53 PM
Hi,
that depends on how many interface you have connected on the Expressway. So if you have two interfaces connected then the internal one is configured with private address, and that is the one you would use on the Control to send the traffic to. But from you question I assume you have one interface connected only therefore you will have to use the public ip address to sent traffic to from vcs control.
Ask if you need more information.
Regards//Andrey
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide