TelePresence and Video Infrastructure

Dear all, There is a ISDN gateway installed in client's network, however, we would like to limit ISDN usage on endpoint. Here is example,All endpoints and movi clients are registered to VCS. All users can make ISDN VC call by adding the ISDN prefix.H...

Hi, The Service URL for TMS is https://tms-update.cisco.com/webservices/product/v1.0/Software/SoftwareService_ESAnd as far as I know it's (e.g.) used to determine if a service contract for a device is valid, when it expires etc.I would like to know i...

HiKindly i have confused between TMS , MCU , my concerns are the following below : what is the main different between TMS , MCU ?when can i use TMS , MCU in network , in the words when i shall i need TMS and when  shall i need MCU ?shall i need to in...

Hi all,was anybody able to register Ekiga video softphone to the VCS using SIP protocol? It works without any problems with PVX softphone (no authentication, simple URI under username and VCS IP address for the SIP proxy and registrar and everything ...

Hi Guys,I don't have that much knowledge about video over ISDN, just have a question about the bandwidth on 3241. Here are two specs from the Data Sheet:Video resolutions up to high-definition 720p at 30 frames per secondCapability for up to 120 voic...

Hi All, I was just trying to generate self signed certificate for my VCS-E and VCS-C for running the MRA feature. i have followed the " Cisco VCS Certificate Creation and Deployment Guide X8.1 for that. i am facing some issue to generate server.pem. ...

Can somebody please tell me the power consumption of the SX20 - Codec in Standby - mode?

Hi,I noticed there is a 'Recursive' parameter one can set when searching the phonebook via the API. In the documentation it says that this parameter can only be used when searching the local phonebook.Is there any reason this is the case and is there...