Wall mount for 7912 IP Phone

[chadthompson]

We currently use the 7912 series IP phones and are looking for a way to mount them vertically. We have purchased a locking wall mount (http://www.cisco.com/en/US/products/hw/phones/ps379/prod_installation_guide09186a00800a8689.html) that is supposed to work with all 7900 series phones. However, it using mounting pin holes to mount to a phone and these pins holes do not exist on the 7912 model phone. Please explain how this mount is supposed to be installed to the 7912 phone.

[tbramwe · Accepted solution]

Chad:

Here's the universal wall mount kit install guide.

http://www.cisco.com/en/US/products/hw/phones/ps379/prod_installation_guide09186a00801d0356.html

It has the 7902, 7905, 7912 models shown.

HTH

Tom

[Rob Huffman]

Hi Chad,

Just to add a note to Tom's good post, I am pretty sure that the 7912 uses a different Wall mount kit. Have a look at the different part numbers;

7905,7912

CP-LCKNGWALLMNT2=

7940,7960

CP-LCKNGWALLMOUNT=

You probably ended up with the Wall Mount Kit shown in the attached doc;

http://www.cisco.com/en/US/products/hw/phones/ps379/prod_installation_guide09186a00800a8689.html

Hope this helps!

Rob

Please remember to rate helpful posts.....