cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
437
Views
10
Helpful
2
Replies
Grishazahid
Beginner

SX80 videocalls with Polycomm Real Presence Group 310

Hello!

Is there any ability to make videocalls between Polycomm Real presense group 310 and Cisco SX80?

I have found document on Polycom web-site.

https://support.polycom.com/global/documents/support/strategic_partner_solutions/Cisco_Solution_Deployment_Guide_us.pdf

It tolds that Real Precence Group can register to CUCM (as third-party-device) and make videocalls (page 14-15). But do SX80 supports TIP protocol?  So now I don't understand, will videocalls from polycom 310 to sx80 work or not? Hope Community will help

2 ACCEPTED SOLUTIONS

Accepted Solutions
PJMack
Rising star

TIP was only there for connection with legacy Cisco Telepresence endpoint (CTS, etc). Here you'll register both as SIP devices and it should work just fine. 

View solution in original post

George Sotiropoulos
VIP Collaborator

You should be able to place SIP calls between the 2 endpoints, considering that the Polycom will be normally registered as 3rd-party Device.

 

George

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

View solution in original post

2 REPLIES 2
PJMack
Rising star

TIP was only there for connection with legacy Cisco Telepresence endpoint (CTS, etc). Here you'll register both as SIP devices and it should work just fine. 

View solution in original post

George Sotiropoulos
VIP Collaborator

You should be able to place SIP calls between the 2 endpoints, considering that the Polycom will be normally registered as 3rd-party Device.

 

George

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

View solution in original post

Content for Community-Ad

Spotlight Awards 2021