Cisco Unity System Administration using SSL

[Nkechi Latunji]

Hi,

Unity System Admin work fine when I am not trying to use SSL. i tried enabling SSL and the Web/SA will not open, getting the page cannot be displayed error.

I have followed these steps

1. Enable SSL for Web, SAWeb, Status, Avxml.dll

2. Add https://<Unity> in trusted site and set the custom level to low

3. Add the DWORD registry setting of EnforceSSL value of 1 under HKLocal Machine/software/acive voice/sys para /1.0

Again page works fine when not trying to use ssl. I have tried checking the 128bit encryption check box when ssl is enabled, still no luck. Running Unity 8.0

Cheers

Nki

[Justin Brenton · Accepted solution]

Hi Nkechi,

Have you gone through this guide?

http://www.cisco.com/en/US/docs/voice_ip_comm/unity/8x/security/guide/8xcusec100.html

HTH, please rate helpful posts.

Regards,

Justin

www.ucintegrations.com

[Nkechi Latunji]

Thanks Justin,

I had followed 5.x steps to enable SSL for Unity. A qucik look at the link indicates a more involved process for Unity 8.x.

Cheers

Nki