CUCM 10.0 Pub+Sub License

[GUNGIT2012]

Hi,

I have a question about the license of CUCM and CUC as below:

We have 2 CUCM 10.0 (1 Pub+1 Sub) and 1 CUC, CUCM and CUC licenses have been added to PLM of Pub, it is working normally when I open Cisco Prime License Manager of Pub, but Sub and CUC are working on the demo mode of Cisco Prime License Manager, Do I need to add the CUCM and CUC license to PLM of Sub and CUC?

Thanks

[Jaime Valencia · Accepted solution]

Choose one PLM to use, install the licenses on it, then register all your products to it, you don't need to use all the PLMs that get installed 

[Terry Cheema · Accepted solution]

I am guessing you mean, you have added Pub and CUC on the PLM on your PUB and uploaded your licenses there and its fine. But if you to Sub and CUC PLM it shows PLM is operating in DEMO mode.

This is completely normal. You have to use one PLM only.

-Terry