05-11-2021 04:17 AM
Are snapshots still an unsupported option for all Cisco UC nodes? I have to upgrade a single node CUCm system to 12.5 SU4 (from 12.5) and while I am confident all will be fine, I have a 3 hour window to get the upgrade finished, switch version and get all the phones (less than 200) back online. I plan to take a DRS backup before hand and can rebuild and restore to a new VM but was hoping to minimize the outage window in the event of am issue that caused me to have to roll back. Since it's a single node with no subscribers there is no replication to be concerned with. That also means there is no secondary node for the phones to register to in the event of an issue.
05-11-2021 04:23 AM
Yes they are still unsupported. If you'd want to minimize the rollback time it's advised to clone all of the nodes in the cluster before you start the upgrade. Having that said up to this point I have never seen any issues with a switch back to the prior version, although it's for the most been done quite recently on 12.5SU4 to go back to SU3.
05-11-2021 04:29 AM
AFAIK snapshot is still not recommended. Run Upgrade Readiness COP File and this will let you know if you are good to upgrade.
05-11-2021 05:25 AM
Thanks. Yes, I planned to run the readiness test pre-upgrade as well.
I've never had to switch back previously, and w/ the readiness test that does alleviate some of the concern as a lot of the pre-checks are done, just wanted to have some form of opt-out in the event of an issue. I'll look into cloning and see if that's an option. That requires the server to be powered down if I recall correctly?
05-11-2021 06:08 AM
Its a minor upgrade. Go through the release note and read me document for su 4. If you do the process as per the guides things will be okay. Never tried clone. Someone from Community will answer that question
05-11-2021 08:20 AM
Yes cloning is a powered off thing.
05-11-2021 03:05 PM - edited 05-11-2021 03:07 PM
Thanks. The pre-upgrade looked fine other than free space so download ciscocm.free_common_space and will install that prior to the upgrade an re-run the pre-upgrade check to see if that frees up enough space; if not will adjust the high/low water marks and go from there.
I see the TVS and Call-Manager certificate are expired so I may correct those first, take a backup and then do the upgrade, time permitting.
05-11-2021 05:36 PM
Refer the below Gide for certificate.
Since your need to generate TVS and call manger,
05-11-2021 10:01 PM
For the certificate topic you could have a look at this document that I wrote. Cisco UC Certificates Renewal Guide
05-12-2021 08:51 AM
Thanks. I have a great guide that I've used in the past for renewals but I'll review those as well.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide