cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1366
Views
10
Helpful
4
Replies

ISDN Layer 1 status DEACTIVATED | Transmitter / Receiver error

celestinobuque
Level 1
Level 1

Hi everyone,

 

I have a ISR4431/K9 with one E1 connection to our ISP but it has stopped working.

ISP says that the line is ok, but when I run some commands I see that the line is down, what other kind of tests I can do to verify if the problem is on my side?

 

show isdn status

Global ISDN Switchtype = primary-net5
ISDN Serial0/2/0:15 interface
dsl 0, interface ISDN Switchtype = primary-net5
Layer 1 Status:
DEACTIVATED
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0x00000000
Number of L2 Discards = 0, L2 Session ID = 0
Total Allocated ISDN CCBs = 0

 

 

show controllers e1 0/2/0

E1 0/2/0 is down
Applique type is Channelized E1 - balanced
Transmitter is sending remote alarm.
Receiver has loss of signal.
alarm-trigger is not set

 

1 Accepted Solution

Accepted Solutions

Give a shut no shut and see if it makes any difference.

 

Check the physical cable.

 

Check with ISP what crc4 they use, is it crc4 or no-crc4. Accordingly  check the controller configuration and make changes if required to match the ISP.

 

 

 



Response Signature


View solution in original post

4 Replies 4

Give a shut no shut and see if it makes any difference.

 

Check the physical cable.

 

Check with ISP what crc4 they use, is it crc4 or no-crc4. Accordingly  check the controller configuration and make changes if required to match the ISP.

 

 

 



Response Signature


Hi @Nithin Eluvathingal 

I tried shut no shut and no difference.

I asked the SP to check as they have a converter in the middle, i am wainting. (But they brought a phone tester and they could make calls)

Any other steps to check what is going on?

Check What CRC4 they use. Accordingly make changes on CRC4  configurations. 

 

If you  have a spare Port available on gateway  try on that. ISP provide the service through   a Modem or ONTE ? Also Check the cable connecting Your Gateway. 

 

 

 



Response Signature


SP changed the converter and everything is fine now.

VGW-FIG-44-P01-01#show isdn status
Global ISDN Switchtype = primary-net5
ISDN Serial0/2/0:15 interface
dsl 0, interface ISDN Switchtype = primary-net5
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0xFFFF7FFF
Number of L2 Discards = 0, L2 Session ID = 2
Total Allocated ISDN CCBs = 0
VGW-FIG-44-P01-01#

 

Thank u for the support

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: