Hello everyone,
I have a Cisco TelePresence MCU 5320 that keeps showing me the same message after POST: oob_net: reply timeout
I would like your support in order recover the device.
Status LED is Off
Alarm LED is Red
Power LED is Blue
=======...
Hi everyone I have upgraded the CUCM 10.5 to 12.5, now I have to enable Conference Now on all users synchronized via LDAP(AD), feel the Self-Service User ID with their extension because it is blank and give them permission to use Self Care Portal.It'...
Hi everyone, I have a FXO line that is translated to an extension, now the user is saying that he is getting random calls where it shows unkown number as caller ID and no one speaks at the other side, sometimes it happens the whole day.I have asked t...
Hi everyone, I have a WIFI guest network that is under a VRF GUEST and it is supposed receive IP address from a Server which is not part of the VRF GUEST, it is on global. But when I connect to wifi I can not get IP address.The server has its gateway...
Hi everyone, I have a ISR4431/K9 with one E1 connection to our ISP but it has stopped working.ISP says that the line is ok, but when I run some commands I see that the line is down, what other kind of tests I can do to verify if the problem is on my ...
Hi @Maren Mahoney Hi everyone I have used Bulk to try to populate the information required with one user for test, but i get the following error:========================================================================Warning LDAP Sync status is enabl...
Hi @Nithin Eluvathingal I have delete my user and resync it.Now I have Standard CMM End Users, Standard CTI Enabled and Conference Now Information is enabled all automatically, but I still dont have the Self-Service User ID field with the extension ...
Hi @Nithin Eluvathingal Thank you for your reply, is there a way to make all the users local with a single click?As doing one by one would be almost the same as enabling the conference now feature for each user Regards
