10-27-2014 11:47 AM
I am unable to log into Cisco Prime Collaboration 10.5.1 in any browser. It give me the error:
Server returned error -> RequestError: Unable to load j_spring_security_check status: 500
I have uninstalled Java, reinstalled it and tried many different versions but none seem to work.
What is the recommended version of Java and browser that needs to be used?
10-29-2014 02:45 PM
The issue was finally resolved by rebooting the Guest OS in VSphere. Took about an hour to finally come back up, but eventually did. You can view the status of the applications by SSH into the machine and typing:
admin# show application status cpcm
11-05-2014 11:57 PM
Hi Jamesvc,
I faced this issue also and reboot the server and it work but the issue come back again
should be there is a solution for this !!
12-09-2014 02:19 AM
did you find a final solution for it as I'm facing this issue
12-09-2014 08:21 AM
Hi.
Does that happen when you are being forced logged out on timeout and you try to log back in using the same browser session ?
/Phil
12-09-2014 08:32 AM
Hi Philippe,
No, it just happened when I try to login this morning
and I can't login till now
Thanks
12-09-2014 08:44 AM
What browser and browser version are you using ?
12-09-2014 08:55 AM
The recommendedFirefox version 24 esr
i have the same error when trying with ie and opera also
12-09-2014 09:08 AM
Can you clear the browser cache and re-try ?
12-09-2014 09:45 AM
Yes I have tried to clear all including cookies but with no success
12-09-2014 10:08 AM
Then I advise you restart the application processes (not the server). For this, please login to the Prime Collaboration CLI as admin and issue the following commands:
application stop cpcm ==> wait for a success completion message
application start cpcm ==> wait until all the processes are up
use the following command to check the processes status
show application status cpcm
12-09-2014 10:47 AM
Ok, I'll try this
i have tried before to reset the server and it solve the issue but it happened again then I reinstalled it then it happen again
i'll try tomorrow your advise and feedback
thanks
12-09-2014 10:00 PM
I saw that happening a couple of times on my lab, not only with 10.5.1 but it was always after forced logout due to timeout, and simply removing everything from the login url except the server IP address would solve the issue (hence my first question). So in your case its different and its something that engineering is not aware of. So please advise in case it happens again after going thru the steps I detailed in my previous reply and we will set up a webex to investigate.
/Phil
12-10-2014 12:32 AM
Thanks a lot Philippe for your care
I'll update you with the results
12-16-2014 04:30 AM
Philippe,
I have the same issue. Only one user ID is impacted, but that ID face this issue all the time. We've tried to configure the user as LDAP and as local user as well, but issue still exist. The user doesn't contain any special character, only letters.
Application restart didn't help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide