SIP trunk CUCM to CUCM down local=0

[Sergey 1907]

I have a SIP trunk to CUCM 9 server 192.168.0.10 from CUCM 12.5(SU4) server 172.16.10.243 through a tunnel (Media Termination Point Required cheсked). Ping goes in both directions, telnet to port 5060 are open. The WWW control pages CUCM's are available, the call manager service is running and the SIP profile is in TCP mode. Everything seems to work but!
SIP trunk status down and Status reason local = 0
What could be? what's the status??

[Roger Kallberg]

A few things to check.

• Are there more nodes in the cluster? If so are all of them defined as targets on the trunk?
• Do you have "Run on all nodes" set?
• Are each side of the trunk setup to use SIP option ping?

Those would be the top of mind things to check based on the given information.

[Sergey 1907]

Hi Roger

1) Yes and Yes

2) Of course

3) Yes

What is Status reason local = 0 (Status reason local = 1 2 3 i know )) )?

[Roger Kallberg]

Not sure what local = 0 means, I can't find any reference for that either.

[Sergey 1907]

I also searched, but could not find (((

[Nithin Eluvathingal]

its a bug. Have a look on bug ID CSCuy59701

[Sergey 1907 · Accepted solution]

I have solved this problem. On the other side, the Translation pattern would not be configured. And also on ASA there was an inspection for streaming protocols