I am using CUCM with PSTN/E1.
I am able to receive calls (Inbound) but unable to make calls (Outbound), what can I do to resolve it?
When I receive calls:
May 11 18:47:44.559 GMT: ISDN Se0/1/0:15 Q931: RX <- SETUP pd = 8 callref = 0x69D3
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98383
Exclusive, Channel 3
Calling Party Number i = 0x1181, '258842912221'
Plan:ISDN, Type:International
Called Party Number i = 0xC1, '0957700'
Plan:ISDN, Type:Subscriber(local)
High Layer Compat i = 0x9181
Sending Complete
May 11 18:47:44.573 GMT: ISDN Se0/1/0:15 Q931: TX -> CALL_PROC pd = 8 callref = 0xE9D3
Channel ID i = 0xA98383
When I make calls (Unable):
May 11 18:49:02.876 GMT: ISDN Se0/1/0:15 Q931: TX -> SETUP pd = 8 callref = 0x0003
Sending Complete
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98394
Exclusive, Channel 20
Display i = 'IT'
Calling Party Number i = 0x0081, N/A
Plan:Unknown, Type:Unknown
Called Party Number i = 0x80
Plan:Unknown, Type:Unknown
May 11 18:49:02.921 GMT: ISDN Se0/1/0:15 Q931: RX <- STATUS pd = 8 callref = 0x8003
Cause i = 0x82E328 - Information element not implemented
Call State i = 0x01
