01-31-2016 09:17 AM - edited 03-01-2019 12:34 PM
Hi Everyone,
The support forums have been a great help wanted to thank everyone for their input. I'm upgrading to 2.2(6) from 2.2(3d) and during the auto install I'm getting stuck at 65% on my Fabric Interconnect. I Tried to force it with manually but it will not work. Any suggestions?
Thanks
01-31-2016 10:13 AM
Hi S,
So you are most likely hitting this bug
https://tools.cisco.com/bugsearch/bug/CSCun79792/?reffering_site=dumpcr
Your /var/tmp folder is likely above 10% which is causing this pre-check to fail. You will have to open a TAC case for them to load our plugin which can clear this error. Let me know if you have any other questions.
Regards,
Qiese Dides
02-08-2016 01:55 PM
Hello,
As Qiese suggested you may need to clear out that directory. If this is pre-production, you may opt to just reboot the FI that is stuck and it should clear the directory as well. I would still make sure you address the /var/tmp issue accordingly, however, the reboot will help to complete the upgrade.
--Wes
02-08-2016 10:33 PM
see https://supportforums.cisco.com/discussion/12745436/upgrade-failure-223d-226d
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide