Be6k disk

[1620415]

 We replace be6k disk because we found to be defective. the status po new replacement unconfigure good. Do we need to do configuration for new replacement?

[Nithin Eluvathingal]

Moving this topic to UCS community as this can be answered by server team.

[Kirk J]

Assuming the failed disk was part of a VD/raid volume, the raid controller 'should' auto use the disk to rebuild, assuming the disk is equal or larger capacity and type.

I have seen a few instances, where you had to mark the replacement 'unconfigured good' disk as a 'hot spare' before the raid volume would use it to rebuild/repair the raid volume.

Kirk...