I have got a problem creating HX stretch cluster v5Got two sites with two Fabric Interconnects and two 240c servers each.I have provisioned 2 servers in SiteA and two in SiteB. Servers deployed as v5.0.2c. Works fine.Management IP of the four Fabric ...
Forum Posts
I have a UCS 220 M4 rack server. I want to know if we can add a GPU to it and use it as a high-end GPU workstation. If yes, please help me with the compatible GPU and necessary accesories for the same.
Is there a PowerShell script or a GUI in UCSM which I can use to check which servers in my UCSM environment do not have redundant connections to the FIs? For example, I have one server (Cisco UCS C220 M4S) with only 1 CPU (Intel(R) Xeon(R) E5-2630 v3...
good afternoon friends, can we configure redundant nic interface in UCS 240 M4 server If yes then how can we configure. Please tell me I shall be thankfull to you.
Hi, Having some trouble setting up a new UCS server. I'm trying to replace a damaged server with a new one. I'm using 3 brand new drives (Unconfigured Good) and 3 from the old server that was a part of a RAID 5 setup (Online). I'm not able to install...
I have a Cisco UCSC-C220-M4S that was running Firmware 4.1(2g), and have upgraded to 4.1(2l). I've attempted to enable the CPU Autonomous CState via CIMC multiple times and after each reboot the setting is reset back to disabled. The Advanced Tab f...
Apologies in advance if this is the wrong place to ask! I bought a Cisco UCS c220 m3 server and intend to use the embedded controller with my sata drive. Unfortunately it’s not recognising the hard drive, and in the bios it’s not letting me enable th...
I am trying to simulate UCS servers but I found UCSPE very unstable from time to time. Also, it lacks a lot of features I really like to practice. Is there any way to simulate UCS on EVE or CIM?
Hi, I trying to install an ENCS5408 but having trouble connecting to the IMC through HTTP. Connecting through SSH and serial works perfectly fine! When connecting through HTTP, I get the login screen but after logging in with the default credentials,...
Dear All Experts,I'm having high CPU Load and IO Delay issues on UCS C-Series.I'm using Proxmox VE (required for existing environment) on several types of servers and I don't experience IO Delay and CPU Load issues like on UCS servers.The impact of I...
Attention Cisco UCS Customers - Cisco has identified an issue that impacts certain SSD drives used in the UCS product line. This issue could cause data loss after the SSD has been powered on for 40,000 hours. A software fix is available. Please re...
Hello All I have a problem with MAC table saturations The problem really appears when the vlan is added to the vnic templates (within 3 minutes), but not when the vlan is created on UCSM or when the vlan is added to the Uplink/Po. When a VLAN is add...
Hi all, I successfully updated the firmware on a Cisco UCS rack server but I am unable to figure out how to programmatically activate the new Cisco IMC Firmware using PowerShell. I am following the instructions in the Cisco Integrated Management Cont...
Setting up my first Intersight managed UCS (done many UCS Manager on-prem). Last night I added our licenses to our Smart Account and told Intersight to "Sync Smart Licensing". Access to features is successfully unlocked...About an hour ago after a so...
Hi!What size are the screws that fix the inner rail to the server? We lost them during relocation, and are planning to order a replacement set. The Installation guide only mentions the screws which are used between the rack tower and the outer rails....
