cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3977
Views
0
Helpful
5
Replies

Boot from SAN and vSphere/ESXi 5.x

thehxman101
Level 1
Level 1

Hello,

This will be our first deployment using UCS 2.x with 5108/B200/6248UP/M81KR Cisco hardware with an EMC VNX5100 directly connected to the Interconnects.

I was wondering if anyone had a cheat sheet/cookbook for these boot from SAN architectures?

Thanks

5 Replies 5

cparik
Level 1
Level 1

Hi,

You can refer to the link below for boot from san settings.

This is a generic document and not specific to your configuration, and it only covers the UCS configuration. But it looks like a good place to start from.

http://jeffsaidso.com/2010/11/boot-from-san-101-with-cisco-ucs/

I hope this is helpful.

--Chetan

cparik
Level 1
Level 1

In addition to the above document. You can also refer the below link to install ESX on UCS blades.

http://www.cisco.com/en/US/docs/unified_computing/ucs/sw/b/os/vmware/install/VMWARE-esxi-install.html#wp1053494

rewilkin
Level 1
Level 1

hx,

Be aware you will not have the ability to zone since you are direct connecting to the FI's

Sent from Cisco Technical Support iPad App

I do believe he can do some LUN masking from the EMC side can he not????

yes, storage masking from the array side is available, but when you direct connect to the FI's, you have no means of zoning.

Sent from Cisco Technical Support iPad App

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card