cdp on vswitch

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-08-2013 04:52 PM - edited 03-01-2019 10:48 AM
any idea how I can enable cdp on a standard vswitch?
- Labels:
-
Unified Computing System (UCS)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-08-2013 10:40 PM
Hi Tony,
Just to be clear, can you provide more details on this?
Are you looking at getting the CDP information when you click the baloon next to the vminc in the vswitch?
./Abhinav
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-08-2013 11:01 PM
you can enable cdp on both direction on a distributed vswitch in graphical.
a VMware vsphere standard switch have cdp on listen mode activate by default, if you want to activate in both direction (to see vSphere server interface from your Cisco Switch ) you have to activate in command line
here the Vmware Vsphere KB for statndard vSwitch

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-22-2013 11:01 AM
looks like I needed to enabled cdp in the network control policy. by default it was disabled.
thanks
