11-13-2015 03:58 AM - edited 03-01-2019 12:27 PM
Dear All,
Hope all doing well....
Below is the error i encountered during installation:
While Installting and configuring UCS C220 M3s server & initially the card is with UCSC-RAID-MZ card which supports RAID 0/1/10.
Now i replaced it with UCSC-RAID-11-C220 mezzanine card so that it supports RAID 0/1/5/10/50.
But when i opened the CIMC of the server & again it is showing that it supports only RAID 0/1/10...
Kindly find the attachments for your reference.
Do i need to enable or configuring any additional options on the BIOS of the server to support RAID 5 ?
Looking forward to hear from you !!! Thanks in advance..
Regards,
Gopi G
Solved! Go to Solution.
11-19-2015 05:49 AM
Please mark the thread as "answered" for future users to see you found the solution and if possible share the info for others facing the same issue.
-Kenny
11-13-2015 05:03 AM
As far as my knowledge....When we insert the UCSC-RAID-11-C220 card is factory configured for RAID 5... We don't need to do any changes...
Please advise it is too critical for me..
11-14-2015 06:22 PM
Hi,
do you have the latest CIMC release, version 2.0(8d) - 09/Oct/2015?
Take a look at the following link.
Hope this helps.
11-18-2015 11:23 PM
Thankyou..Marcelo..Issue Solved
11-17-2015 08:20 AM
The RAID card will support different RAID levels, it is not preconfigured unless you got some sort of appliance based on UCS.
Did you try to create the desired RAID level and got some sort of error message or restriction?
-Kenny
11-18-2015 11:23 PM
Thanks Issue....solved
11-19-2015 05:49 AM
Please mark the thread as "answered" for future users to see you found the solution and if possible share the info for others facing the same issue.
-Kenny
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide