Hello, I need a little help with a poblem I'm having with ethernet during fabric failover with the UCS 5108; I have a fairly vanilla infrastructure (attached image); 2 Nexus 5Ks layer2 northbound of the 62xx fabrics, the fabrics are port-channeled an...
Hi all, I have my UCS manager and I need to make an upgrade, my questions is the VMs I have running do I need to move them from one device to other? or I can do the upgrade with no down time? Can anyone give me a procedure about how I have to do thi...
Hi!It seems that both B series as well C series have board controllers. What is the purpose of the board controller?We have the BMC/CIMC to provide management of the server and read the sensors. The CMC to operate as the "control plane" of the IOM in...
I have a number of UCS C220's and from what I understand you can monitor CIMC via SNMP, but my question is, what do you use to monitor? I've had 2 hard drive failures now where the only indication was alarm & amber lights. I'd really prefer to find...
Hi: I have a Cisco UCS B200 M2, UCSM 2.2(3e). I just created a new vlan 400 (BKP_192.168.6.0). When I proceed to modify the vNIC Templates to add the newly created vlan 400, I receive the following warning message: Modify VlansYour change:Create: N...
Hi, I am trying to add Cisco UCS C200M2 to Opmanager (monitoring tool) with no success. Just want to know the configuration on UCS box.1. do we need to have an acc with admin proviliges to login to CIMC?2. Does UCS support SNMP v2 or we need a separa...
UCS suffered a major melt-down today with both fabric interconnects deciding to reboot. As far as I know I have no HA policy set which would cause a fabric interconnect to reboot on its own. A similar error is on the other fabric interconnect. My ...
Hi: I have a Cisco UCS B200 M2, UCSM 2.2(3e). I just created a new vlan 400 (BKP_192.168.6.0). When I proceed to modify the vNIC Templates to add the newly created vlan 400, I receive the following warning message: Modify VlansYour change:Create: N...
Hi every one, I´m using a Cisco UCS C220 M3 when I tried to install ESXi 5.1.0 Cisco Custom after complete all the process and restart the server. The ESXi did not start it appeared as if there no operating system.Aditionally, before the ESXi install...
Hello, I realize that 16G cards are the only ones supported with UCS 2.1, but since they are EOL, we had to purchase the UCS-SD-32G=I found an explanation that it is possible to run 32G by just upgrading the CIMC software to 2.2(3a) or later. Would t...
Hi there,I have a issue with cisco UCSC C22 M3 server. i am getting beow lg at tech-support command. is there any one who faced same situation?and please advice for further actions which i can take.==== SPD DATA for DIMM B1 ====SPD Format Version :...
Dear All,I am writing this because i have no experience with Nexus switches and this is the first time i will be configuring the switch (Nexus 7010). I know the technology and configuration stuff but what i dont know is how to physically connect the ...
I have Windows Server 2008 running on a UCS C22 M3 system, and I cannot get the serial port to work on it. I have the only external DB9 serial port connected to the console of another system. Windows sees the serial port as COM1. I've tried changing ...
