sanboot primary and seondary

[Dragomir]

How should i be etting my my sanboot to my clariion? Its a active/passive array.

with with vhbas, fc0 and fc1

fc0 goes to fabric A, fc1 going to fabric B

on fabric A, there are 2 spA ports and 2 spB ports

on fabric B here are 2 spA ports and 2 spB ports

what should i put in as the san primary and san secondary targets under fc0 and fc1?

[abbharga]

Tony,

You can configure it something like this:

SAN Primary

     SAN Target primary - spA - port1

     SAN Target secondary - spA - port2

SAN Secondary

     SAN Traget primary - spB- port1

     SAN Target secondary - spB - port2

./Abhinav

[Dragomir]

hi

I have 4 spA ports, and 4 spB which one to use?

[gkumark]

Tony,

I see that you have 2 SPA ports on fab A and 2 SPB ports in fab B. So you can use them as it is. Use SPA ports in fab A only and SPB ports in fab B only.

On Fab A : SPA port 1 and 2

On Fab B : SPB port 1 and 2

Make sure that you zone them right. Zoning would be something like

Fab A:

fc0 + SPA port 1 + SPA port 2

Fab B:

fc1 + SPB port 1 + SPB port 2

This should work fine.

[Dragomir]

my fI-A is connected to brocade1

FI-B is connected to brocade 2

the SP Ports seen on brocade1 are

spA1,3

spB0,2

SP ports seen on brocade 2 are

spA0,2

spB1,3

should my zoning on fabA be, fc0, spA1,3, spB0,2?

and

fab B fc1, spA0,2, spB1,3?