Unified Computing System Discussions

Hi All,We have a scenario here, which EMC support claim that they've see this elsewhere. There is 1 units of CISCO UCS B200 M1 (Palo) with 4 Blades connecting to CISCO Fabric Interconnect 6120XP.CISCO Fabric Interconnect 612XP has configured with UPL...

Hello,we have a small problem with one of our B200 M2 blades.There is a BIOS password set, so we can not open the boot menu. The bad thing is, nobody seems to remember the password. Is there any way to reset it?Best Regards

We are receiving FC SAN connections from an MDS 9513 we do not own, within the same physical building. We have been given a range of WWNN and WWPN to create pools in UCSM.I am not a storage manager, nor much of a systems manager, but I know there are...

Hi everyone, I have installed a Flexpod Environment with 2 Nexus 7k, 2 Nexus 5k, 2 FI 6248UP, 7 Chassis 5108 and aproximately 28 servers B200.All blades are virtualized with ESXi but my customer is looking a slow connection when he tries to connect t...

Hi we need to upgrade the Cisco UCS setup from firmware version from 1.3(1c) to version 2.1(1a). Is that possible to jump from the 1.3 to version 2.1 (1a). Please advise. any websites for the firmware upgrade for the UCS setup/B-blade server/C Blade ...

How should i be etting my my sanboot to my clariion? Its a active/passive array.with with vhbas, fc0 and fc1fc0 goes to fabric A, fc1 going to fabric Bon fabric A, there are 2 spA ports and 2 spB portson fabric B here are 2 spA ports and 2 spB portsw...

Can I connect 2 6248 FIs to an upstream Nexus 5548 (Layer 2 daughter card) for ethernet/LAN connectivity and create a vPC as displayed in the attached pic?

in vsphere why does my vnic shows 40000Mbps. while another host will only show 10000Mbps

Hi,I have one chassis in a UCS 6140 pod that is using 2208 IOM's (all the other chassis use 2104's). This happened due to needing to expand that pod while haveing ony that equipment on hand. Now, I'd like to swap out the 2208 IOM's for 2104's, one at...

Hi!If i use Any configuration as local disk configuration policy and do the raid settings directly to the RAID-cards, am i able to have two raid volumes on C-series under UCSM management?What i would like to do with C240M3 with 6 local disks: 2 disk ...

Hi UCS Community,Curious about use cases for Server Pools. They seem to be suited for quite large UCS installations with tens or hundreds of chassis and blades. Is this the case?We have blades in Server Pools and because of this we can't do something...

Hi,The question is in the title !So, is it possible to know the last reload/reset date or the update time of a server blade B-series ?I could not find this piece of information in the GUI (or via a show command)Many thanksNicolas.          

Does anyone know if UCS B200 M3 supports 1-CPU E5-26xx configuration or any concerns?As I knew, previously B200 M3 with E5 did not support 1-CPU configuration?And I have no clue the reason behind of why it did not support.I would be appreciated and t...