01-13-2014 02:06 AM - edited 03-01-2019 11:26 AM
We have recently installed a few new B200 M3 servers, fully populated with 24 x 16 GB (1866 mhz) DIMMs, 2 x E5-2697 v2 CPUs.
UCS manager shows the DIMMs properly in the inventory tab, but from the General tab, shows "Operating Memory Speed" of 1333 mhz (same speed in the boot messages.
Board Controller: 8.0
Firmware: 2.1.3a
CIMC: 2.1.3a
Anyone know why I am seeing the slower memory speed? What am I missing?
Thanks,
Joe
Solved! Go to Solution.
01-13-2014 02:42 AM
Joe,
Have a look at table 7 here:
https://www.cisco.com/en/US/prod/collateral/ps10265/ps10280/B200M3_SpecSheet.pdf
If you're using 3dpc you'd be stuck at 1333, even if you're att 1866 DIMM and CPU.
M.
01-13-2014 02:42 AM
Joe,
Have a look at table 7 here:
https://www.cisco.com/en/US/prod/collateral/ps10265/ps10280/B200M3_SpecSheet.pdf
If you're using 3dpc you'd be stuck at 1333, even if you're att 1866 DIMM and CPU.
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide