UCS C460 M2 and Tesla GPU UCSC-GPU-A100=

[rugman66]

Hello,

I have a UCS C460 M2 that I would like to install a Tesla A100 GPU card Cisco part number UCSC-GPU-A100=. I need to know if there is a firmware issue that would prevent using it, or if it would be too large. The C460 has one PCIe 16x slot that can accommodate a full height double wide card, but only 3/4 length. I have not been able to find out if the card is 3/4 or full length. If anyone could assist in getting this info I would very much appreciate it.

Regards
-John

[Kirk J]

Looking at the A100 specs on nvidia's page, https://www.nvidia.com/content/dam/en-zz/Solutions/Data-Center/a100/pdf/A100-PCIE-Prduct-Brief.pdf 

266.7 mm /10.5 inches , which is a little bit larger than the 3/4 length (10") specs, should require a full length slot (312mm/12.283 inches)

Kirk...